DIY projects

projects decor holidays misc dollar store crafts
beauty beach decor wood projects outdoors Shop

DIY cholla cactus lamp


This post may contain affiliate links.



I redid the decor in our bedroom in more of an earthy, natural tone.   I previously had a driftwood lamp that I had made when we lived along Lake Michigan, but being in the desert now I wanted something different.  I had gotten these beautiful pieces of cholla wood and knew they'd make the perfect lamp.

What you will need:

cholla skeleton wood
1/2 pvc pipe or conduit pipe
old lamp or light kit
some type of base - I used wood I had laying around. 
wire stripper
drill and 1/2" drill or spade bit

This is how I made mine with the materials I had.  You may not have the same light kit or lamp so you will have to work accordingly.

First I prepared my lamp base by drilling a 1/2" hold into the middle of it.  This is where I will thread the lamp wiring through and where my pipe will stand into.  It was a nice and snug fit putting the pipe into the hole and keeping it up nice and straight.

I took apart the lamp and was left with the full wiring - plug to the lightbulb.  Being an older lamp, I was able to pull the wiring out from the bottom of the light bulb casing.  Here you can see the plug and the other end of the wires that would push into the base of my lamp.  This is how you thread the wire up through the pipe and out the top.



Once I had the wire through the pipe I put my big cholla piece over the top of it all and let it rest in place for now.  Then it was time to reattach the lamp wiring to the base.  For mine, I just had to use my wire stripper and pull back the coating a bit more and retwist up the bare wires.  Then they just pushed right back into place.

 

diy projects

Then I pulled the wires back down through the bottom until the base of the light bulb part rested on top of the chollar wood.  I got lucky - it fit in there perfectly.  I screwed on the top of the lamp base and then the lamp itself was ready to go.  I used a dab of hot glue on the bottom of the cholla wood to secure it in place on top of the wood base and then used twine to attach the two smaller pieces I had just to add to the look of the lamp.  I put a few rubber bumpers on the bottom of the wood and that was enough to make it sturdy as well as make it high enough that the chord sits under it nicely.



I found the little lamp shade at a local thrift store and just love how it looks especially at night when it's turned on - it looks like angel wings on the wall.



Looking for a few more cactus related DIY's?  I've got another really cute cactus wire lamp that you can easily make yourself.

Have you seen our incredible PVC pipe art?  Learn how to lean how to make it youself!




 CrazyDIYmom.com   Contact Us   Privacy Policy   Disclaimer   About me